Chunk lance

Chunk_lance

Chunk_lance allows to run a sequence of monthly model jobs in one big job.

A GEM/GEMCLIM/CRCM5 simulation usually consists of a sequence of month jobs.

Each monthly job is made up out of 3 parts:

1. auto_launch (copies restart files from previous month, prepare config files for new month)
2. entry (only in LAM mode, prepares driving data)
3. model (main model job)

Chunk_lance will run a series of these 3 jobs, checking at the end of each model job if there is still enough time to calculate another month. If yes the 3 jobs will get executed for another month, if not an new chunk_job will get submitted.

In case the model job fails it will automatically get reexecuted up to 4 times.

Since the running job is not always called "chunk_job" one cannot see anymore from the job name how far the simulation has progressed. But one can always have a look at the listings directory and also a log file is kept in the config file directory called "chunk_job.log".
This file is essential for the whole chunk_job procedure. The chunk_job itself will check this file to determine which job to execute next. Therefore this log file must only be removed if one wants to restart a simulation from the beginning.
However, to rerun part of a simulation one can alter the log file by hand. Just make sure there is never a blank line at the end of the log file since the chunk_job only checks the very last line of the log file!

To start a simulation using Chunk_lance one only has to set the model environment (for example with '333') and execute "Chunk_lance" in the config file directory.

The time up to which one chunk_job will be running can be set in the file 'configexp.dot.cfg' with the parameter 'BACKEND_time_mod'.
On guillimin one job is allowed to run up to 30 days (2592000 sec).
On colosse one job is allowed to run up to 2 days (172800 sec).

Restart using Chunk_lance

In case a simulation stoppes one first has to find out which job (auto_launch, entry or model) was the last one that finished propperly.

The best way is to look at the listing but the log file "chunk_job.log" can also be used for indications.

entry or model job crashed

In this case the last line in the log file should be:

   ... entry ..._E starting at ...
or
   ... model ..._M starting at ...

If the entry or the model job crashed it is enough to restart the simulation by executing "Chunk_lance" again in the config file directory.

auto_launch crashed

In this case the last line in the log file should be:

   ... continue_with_next_job ... starting at ...

If there is NO file called "continue_with_next_job" in your config file directory taks a copy of the file "last_continue_with_next_job":

  cp continue_with_next_job last_continue_with_next_job

Then restart the simulation by executing "Chunk_lance" again in the config file directory.