Debugging CRCM5

1) The grid
If you have general problems right away in more than one point of your domain I would you a little test grid: Either global 24x12 points or, if you need to run LAM, use a grid 60x60 points.
I usually use these test grids:

    /home/winger/gem/v_3.3.3.1/Config/Test/24x12
    /home/winger/gem/v_3.3.3.1/Config/Test/LAM_60x60


2) Debugging mode?
Do you want to use a debugger?
If yes, I suggest you compile all routines you want to debug in debugging mode by adding "OPTIL=0 FCOMPF=-debug":

   make routine.o  OPTIL=0  

       FCOMPF=-debug 

or, if you want to compile all your routines or modifyed a *.cdk

   make objloc  OPTIL=0
     FCOMPF=-debug 


Create the executables with 
   make gemclimdm_nompi  OPTIL=0
     DEBUG=-debug 
   make gemclimntr_nompi  OPTIL=0
     DEBUG=-debug 


3) Executing just the executable
Does your entry/model crash? If not, the easiest way is to start the simulation the normal way with:

    Um_lance

Then kill the entry/model job (the job you want to debug) once it started. 

Go into the execution directory:

    cd /home/${USER}/MODEL_EXEC_RUN/${TRUE_HOST}/${UM_EXEC_exp}
   


3a) If you want to debug the entry execute:

    .
     RUNENT_upload/configexp.cfg 

Go in the entry working directory:

    cd 'RUNENT/work'
    
Execute the executable:

    '../bin/ATM_NTR.Abs'

Or, if you want to use the debugger pgdbg:

    'pgdbg -dbx '../bin/ATM_NTR.Abs  &


3b) If you want to debug the model execute:

    .
     RUNMOD_upload/configexp.cfg 

Go in the entry working directory:

    cd 'RUNMOD/work'
    
Execute the executable:

    '../bin/ATM_MOD.Abs'

Or, if you want to use the debugger pgdbg:

    'pgdbg -dbx '../bin/ATM_MOD.Abs  &